Product Description

Forster Products has solved two problems common to many reloaders: misaligned die locking rings and damaged die threads. Either of those situations can occur when a locking ring cross-screw is fastened too tightly or if the locking ring threads are improperly mated with the die threads. Forster's locking ring design features an easy to use cross bolt that connects the two ends of the ring instead of a traditional screw design that tightens directly into the threads of the die. The result is a more reliable alignment with no canting and no damage to the die threads which remain untouched by the cross bolt. Tightening or loosening the cross bolt requires a 7/64" hex wrench. The Forster cross bolt locking ring will fit any manufacturer's standard 7/8" X 14 dies. They are supplied with all Forster's high quality Bench Rest® Dies.

Product Description

Redding Competition Seating Dies deliver the precision and accuracy preferred by the most discriminating handloaders. Now you can easily covert your conventional seating die to a precision micrometer seating die for use with VLD bullets for precise, repeatable bullet seating depths to within 1/1000th of an inch and potential world-record accuracy. Designed for all seating dies that use a seat plug with ½-20 threads. Easily changes from one die to another, just match the number on your current seating plug to the corresponding bullet seating micrometer number.

View Redding Micrometer Reference Chart here.

Product Description

Upgrade your Redding Standard and Type S dies with a carbide sizing button. Makes inside neck sizing smoother and easier without lubrication. Available for bottleneck cartridges in 22 through 30 caliber. The carbide button free floats on the decapping rod allowing it to self-center itself in the case neck. The kit comes complete with a carbide button, retainer, and spare decapping pin. Decap rod not included. Not intended for use on dies other than Redding standard and Type S neck and full length dies.

Product Description

Redding Competition Long VLD Seater Stems. Stems are 1-3/16" long.

Product Description

These machined aluminum split pliers are designed to loosen Redding dies when screwed into the press. These pliers fit the die body lock ring, which frequently is in a jammed fit with the die and the top of the reloading press. The smaller hole fits the smaller knurled lock nut on top of the reloading die that locks down the decapping assembly. The contoured fit of these pliers prevents the damage we routinely see on lock rings from handloaders using adjustable pliers.

Product Description

These steel die lock rings from Hornady clamp around the entire circumference of the die body. The lock screw squeezes the lock ring around the die with constant pressure across the threads - no jam screws. These rings have a flat on each side for wrench use. Sure-Lock Rings fit all standard 7/8""-14 reloading dies.

Product Description

Redding Competition Standard Length VLD Seater Stems. Stems are 1" long.

Product Description

RCBS Decapping Unit

Product Description

The Sinclair Micrometer Top allows the handloader to convert existing L.E. Wilson seaters to micrometer seaters. The top is constructed of stainless steel and is graduated in increments of .001 inch. To use, remove the existing seating stem from your L.E. Wilson Seater cap, and install in the Sinclair Micrometer Top. Now you are ready to make quick and easy changes to your cartridge's overall length. The top utilizes your existing seater stem or you can purchase an additional stem. Stem is not included.

Product Description

• Pack of (2) Breech Lock Quick Change Bushings
• Allows instant, accurate die changes
• Fits Lee reloading presses with the Breech Lock System